How it΄s done:
- First of all one has to twist off the locking ring and remove the battery holder.
Foto 1
- Afterwards one unscrews the covertec wheel with a hex key.
Foto 2
- Opposite the covertec wheel an allen screw is recessed; that one has to be screwed off.
Foto 3
- Now the retral section and the golden ring on the whole can be detached.
Foto 4
- After this the iron ring holding the battery holder's tray has to be removed.
Therefor one detaches the two golden pins. They are to be knocked out with a hammer and a pin. Afterwards one can remove the ring as well as the tray.
Foto 5 and
Foto 6
- Take off the three allen screws being attached in three of the twelve emitter's holes next.
One can remove the emitter as well as a rubber- and a plastic-ring subsequently.
Foto 7 and
Foto 8
- Now the golden plate at the activator has to be lifted.
Foto 9
- The same with the plastic plate lying underneath. Hereby patience is required, for one must not damage this plate!
Foto 10
- Hereupon one has to detach the screw lying underneath the rubber mat. Therefor one lifts up the rubber with a flat item slowly and unscrews the emerging screw.
Foto 11
- After this one can pull out the whole electronics from the hilt backwards.
Foto 12 and
Foto 13
- At last one unscrews the screws holding the soundboard's chassis together, so one can take off the blade and pull out the LED-strip with its holding.
Foto 14 and
Foto 15
Now the dismounting is completed.
Have fun with tinkering, your Team Saberproject!
|
Das Lichtschwert
···