- First the locking ring is to be screwed off and the battery tray to be removed.
Photo 1
- Now one loosens the screw at the emitter (do not screw it off completely) and
strips off the emitter over the blade. Photo 2,
Photo 3
- After that the black ring is to be screwed off and the blade to be taken off.
Photo 4,
Photo 5
- Next one has to screw off the big screw on the black plastic covering
underneath the emitter; after that the two small screws within the covering.
Photo 6,
Photo 7
- Remove the two small screws underneath the emitter.
Photo 8
- Unscrew the big screw at the activator box; now one can detach the box with the activator’s plate in several parts.
Photo 9,
Photo 10
- Afterwards remove the two screws that hold the fixture of the switch; then one can
take off the fixture and press out the switch.
Photo 11,
Photo 12
- Desolder the switch and detach the screw of the clamp, which can be stripped off
after the two wires have been laid into the hilt piece.
Photo 13,
Photo 14
- After that the metal pin is to be knocked out of the hilt piece with a thorn or a pin.
Now one can remove the chassis with the electronics from the front of the hilt.
Photo 15,
Photo 16 und
Photo 17
Naturally the assembly works the complete way around.
The Lightsaber
···
