For the disassembly the following steps are necessary
- Detach the locking ring and the battery tray
Picture 1
- Drop off the activatorbox at both ends carefully
Picture 2
- Unscrew the screws underneath and detach the black holder
Picture 3
- The latching switch still is connected to the box via two little screws.
Unscrew those; lift the shifter and push it into the hilt piece
Picture 4 and
Picture 5
-
Both copper eyes are to be detached with a thin item cautiously
Picture 6 und
Picture 7
- Underneath the copper eyes is a screw that has to be removed.
Afterwards detach both mountings.
Picture 8
- Unplug the two golden pins on either side with tongs
Picture 8 und
Picture 9
- Detach the little screw above the great copper eye.
Picture 10
- Now extract the blade and the whole holding to the front.
Picture 11
- Seperate the soundboard's casing from the blade holder (detach the adhesive tape)
and cut the cable connections to the LED strip.
Picture 12
- Knock both metal pins out of the blade holder with a sledge and a bolt (or a blunt nail)
Picture 13
- Remove the little rivets, which only are affixed with some adhesive tape
Picture 14
- Unplug the little tube in the blade holder.
Picture 15
- Remove the blade from the blade holder.
Picture 16
- Beat the little metal pin in the blade carefully into the LED-strip's
holding with a sledge and a thin nail - but only far enough to be able to seperate the blade from the LED-holding!
Picture 17 and
Picture 18
- After uncovering the LED-strip draw off the foam.
- Cut the LED-strip's holding open on either side.
Now the LED-strip can be seperated completely
Picture 19 und
Picture 20
The Dismounting is finished!!
|
The Lightsaber
···